Hydro-Probe XT Digital Moisture Sensor
The Hydro-Probe XT is a digital moisture sensor that is designed to measure moisture continuously in the flow of material across the ceramic sensor faceplate. Reading at 25 times per second the sensor detects rapid changes in moisture, providing a linear digital or analogue output.
Digital technology provides precise, linear moisture measurement.
Advanced Digital Signal Processing
The sensor response may be adjusted remotely using the Hydro-Com software to minimise the effects of noise of the measured signal. Advanced Digital Signal Processing provides a clear signal with a rapid response.
Choice of measurement modes for optimising sensor performance in a variety of applications and material types.
Fully Temperature Compensated Measurement
The sensor internally adjusts for mechanical changes due to temperature fluctuations
Easy to Interface
Two analogue outputs and digital RS485 communications and configurable digital inputs / output make the sensor simple to integrate into a control system.
Measuring in the Mix
Measuring at 25 times per second the sensor continuously detects changes in the moisture of the materials throughout processing.
Temperature output is available to provide a readout of material temperature.
The Hydro-Probe XT can be remotely configured using Hydro-Com diagnostic software. All readings and sensor parameters are available including the type of output and filtering characteristics.
A unique feature is the 'angling' of the sensor face plate to the flow of the material. This ensures consistent flow characteristics over the sensor face and prevents build up or "clogging" of the material at the sensor. The sensor should be positioned at an angle of 60 degrees to the flow but this may be easily adjusted to suit the flow characteristics of any material.
The 'averaging' mode continuously provides the 'average' reading of moisture from the start of reading to any time selected - normally the closing of the hopper door. Averaging, bin empty alarms and signal processing performed internally by sensor.
Accuracy of Measurement
All measurements may, if required, be calibrated to an accuracy of +/- 0.2%. If used to reach a target the accuracy can be better than 0.1%
Simple Power Requirements
The Hydro-Probe XT may be powered from a 15-30V dc supply. Multiple sensors may be driven from a single power source.